About off grid solar system

The principle of solar generator photovoltaic system Diagram in the daytime, under the light conditions, solar modules produce a certain amount of force is formed by series-parallel solar cell matrix components, making the square voltage reaches the system input voltage requirements. Through the charge controller to charge the battery, it will be converted from light energy stored up energy.

 

Evening batteries provide input power to the inverter, by the action of the inverter, the direct current into alternating current supplied to the power distribution cabinet, distribution cabinet by the switching action of the power supply. Discharge of the battery pack case is controlled by the controller to ensure that the normal use of the battery. PV power plant system also limited load protection and lightning protection devices to protect the system equipment from lightning and over-load operation, maintenance, use of safety system equipment. Solar energy  → electrical energy → light energy → chemical energy.

 

Part of the photovoltaic system is composed of square solar cells of off grid solar system, battery, charge controller, inverter, AC power distribution counters, automatic solar tracking system, automatic dust removal system, solar modules and other equipment. Its role is to various pieces of equipment: solar cell matrix in the presence of light (either sunlight or other light emitters generate light), the cells absorb light energy, different signs appear accumulated charge across the battery terminals, which produce photovoltage which is the" photovoltaic effect. " In the photovoltaic effect the role of force is generated at both ends of the solar cell, light energy is converted into electrical energy, energy conversion devices. Silicon solar cell is generally divided into single crystal silicon solar cells, polycrystalline silicon solar cells and amorphous silicon solar cell three. Its role is to store the battery pack power when the solar cell matrix issued by the light and are ready to supply the load.

The basic requirement for solar backup power are used:

a. Self-discharge rate

b. Long life

c. Strong deep discharge capability

d. High charging efficiency

e. Low-maintenance or maintenance-free

f. Wide operating temperature range

g. Low prices.

Our current batteries and solar power generation systems supporting the use of lead-acid batteries and are mainly nickel-cadmium batteries. Supporting more than 200Ah lead-acid batteries, generally used fixed or sealed lead-acid industrial batteries, each battery is rated at 2VDC; supporting the following 200Ah lead-acid batteries, generally used in small sealed maintenance-free lead-acid batteries, each only the rated battery voltage is 12VDC. Charge controller is able to automatically prevent battery overcharge and over-discharge device. Because of the battery charge and discharge cycles and the depth is an important factor in the decision to discharge the battery life, so they can control the battery overcharge or over-discharge charge controller is essential equipment. The inverter is a direct current into alternating current equipment. Since solar cells and batteries is a DC power supply and the load when the AC load, an inverter is necessary. The inverter according to operating mode can be divided into stand-alone inverters and grid inverter. Stand-alone inverters for solar power generation systems operate independently, as a separate load. Grid inverter for solar backup generator and network operation. The inverter output waveform can be divided by the square wave inverter and sine wave inverter. Square wave inverter circuit is simple, low cost, but large harmonic components, generally used for several hundred watts and less demanding on the harmonic system. Sine wave inverter high cost, but it can be applied to a variety of loads.

Inverter protection function:

a, Overload protection

b, Short circuit protection

c, Reverse protection

d, Undervoltage protection

e, Overvoltage protection

f, overheating protection

AC power distribution cabinet which is on standby inverter switching a major role in solar power kit off , to ensure the normal power supply system, as well as measurement of electrical energy on the line.